Replace Valve Stem Seals (Cylinder Heads Installed)

Replace Valve Stem Seals(Cylinder Heads Installed)

Remove, Disconnect

Remove camshafts - see operation "Camshafts, Remove and Install".

Remove spark plugs with KM-194-E. Pull hydraulic valve lifter out of cylinder head with KM-845.

Lay hydraulic valve lifters aside in correct order, to ensure mat they can be allocated to the valves on reinstallation.

Required special service tools:

Installation Head	MKM-889-2
Thrust piece	MKM-889-5
Installation Shaft	MKM-889-9
Support	MKM-889-11
Lever Arm	MKM-889-12
Joint	MKM-889-13
Removal Head	MKM-889-15
Pliers	MKM-889-16
Compressed Air Adapter	MKM-889-17

Remove, Disconnect

Install compressed an adapter (1) in ignition plug bore and pressure cylinder with compressed air.

Fasten joint (4) to lever arm (3) and install on cylinder head with supports (5) and assembly shaft (6) - assembly shaft must sit centrally on cylinder head.

Fasten removal head (2) at lever arm - ensure that when pressing down, the removal head is seated vertically on the upper valve spring plate. Press down valve springs and remove valve cotters with KM-889-16.

Important!

Do not use a magnetic tool to remove the valve cotters.

Remove, Disconnect

Remove valve spring cap and valve spring.

Notice:

For valve stein seals of exhaust valves (cylinders 1-3-5), the supports must be modified so that assembly shaft is positioned towards rear ( towards bulkhead) - ensure that when remover assembly head is pressed down, it sits vertically on valve spring cap.

Remove, Disconnect

Remove valve stem seals with KM-840

Install, Connect

Push enclosed assembly sleeve (2) on valve stem and lightly coat with engine oil. Place new valve stem seals (1) onto valve guide using KM-835-A and carefully drive in to stop with light blows. Insert valve spring and upper valve spring cap.

Install thrust piece (4) in assembly head (5). Insert valve keepers (3) in installation head with broad side towards plastic ring and clamp by pushing the plastic ring (6) Forward Fasten assembly head to lever arm - ensue that when pressing down the assembly head is seated vertically on the upper valve spring plate Allow valve keepers to engage by moving up and down - ensure that valve keepers are correctly seated.

Remove valve depressor from cylinder head

Install spark plugs with KM-l94-E - tightening torque 25 Nm /18 Ibf. ft. Lightly coat hydraulic valve lifter with engine oil and insert in correct sequence into cylinder head.

Install camshafts - see operation "Camshafts, Remove and Install".

Сделано по материалам TIS

Russian ver.